Splice Cyliders by Long Shaft Tank Joint Welding Rotator

Splice Cyliders by Long Shaft Tank Joint  Welding Rotator 

Standard Technical Parameters：

Max loading ： 20 Tons

Workpiece Diameter ：450--3500 mm

Shaft Pipe Diameter ：114 mm

Shaft Pipe Length：6000 mm

Linear Speed ：100-1000 mm/min

Speed adjust ： By VFD

Motor Power ：1.5 Kw

Altitude difference：100 mm

Couplings type ：Universal coupling

Introduction:

   Long tank were jointed by 2 or more shell . So we may use this type equipment to joint many short shell .Also we may put the jointed tank on this type machine, and then the worker may point weld and welding the long seam on the tank. At first you put  2  short shells on the equipment , and then you may drive the motor . the 2 shell will near and near ,and then weld the joint.

Please notice:

1)      Thte long pipe is  tape on the base, so the shell may extrusion, you may joint the shell one by one.

2)      The long pipe is standard on the base , You may weld the shell several workplace. 

3)      The distance between the wheels and wheels may adjust . bolt fixxed.

4)     The control box may by hand in the shell.